Applies To
Intermatic SCG25K and SCG40K I-PURE Salt Chlorine Generators.
Question / Problem
How do I wire my I-PURE Salt Chlorine Generator to an automation system or time clock using 120 VAC or 240 VAC?
Safety Warning
Warning: Risk of fire or electric shock. Disconnect power at the circuit breaker or disconnect switch and verify that power is off before installing or servicing the I-PURE Salt Chlorine Generator. Follow national and local electrical codes. Installation and service must be performed by qualified personnel.
Common Installation / Application Conditions
The I-PURE Salt Chlorine Generator can be connected to an automation system or time clock using the applicable 120 VAC or 240 VAC configuration shown in the I-PURE Wiring Diagram for your model.
Step-by-Step Resolution
Review the I-PURE Wiring Diagram
Refer to the I-PURE Wiring Diagram for your model and identify the connection details for the applicable 120 VAC or 240 VAC configuration.
Connect the I-PURE to the Control
With power disconnected and verified off, follow the I-PURE Wiring Diagram to connect the Salt Chlorine Generator to your automation system or time clock based on the voltage of your installation.
Verify Operation
After the wiring is complete and the installation is safe to energize, restore power and confirm that the I-PURE turns ON when the automation system or time clock calls for it.
Tips / Additional Notes
- If you have additional questions, contact Intermatic Technical Support at 815-675-7000.